Classrooms on different floors (room sound check)
Why GPS cannot separate stacked classrooms, how the room sound check does, and how to set it up.
3 min read
The problem: same coordinates, different floors
GPS gives a position on the map, not a floor. A classroom on the second floor and the one directly above it on the third share the same latitude and longitude. Phone GPS indoors is typically accurate to 10-50 metres, and its altitude reading is too unreliable to tell floors apart. No phone browser can reach ±1 m: that needs survey-grade equipment.
So with GPS alone, a student sitting in the room above could appear to be in your classroom.
The solution: a signal only your room can hear
When the room sound check is on, your classroom device plays a short, near-silent signal (18-19.5 kHz) through its speakers. Students’ phones listen for it when they join and at every presence check.
- Floors and walls block it. Concrete slabs absorb this kind of sound, so phones on other floors and in neighbouring rooms cannot decode it.
- It cannot be forwarded. The signal changes every 30 seconds, and phone calls and voice notes strip these frequencies, so a friend cannot relay it.
- Nothing is recorded. The phone analyses the sound on the device and only sends the decoded number. The microphone switches off straight away.
Most people cannot hear the signal at all. A few, usually younger listeners, may notice a faint high whine at high volume; lower the volume until no one does.
Modes
| Mode | Joining | Presence checks |
|---|---|---|
| Off | Location checks only | Code only |
| Advisory | Allowed; students whose phone did not hear the room are flagged in the roster | Same |
| Required | Blocked until the phone hears the room | Answers without the room signal are refused |
Administrators set the default in Settings → Default room sound check. Teachers can change it per class when starting it, or live from the class page; for example, switch to Advisory if the speakers fail.
Setting up a classroom
- Use the classroom computer or projector laptop connected to the room speakers. Phones and tablets work too, but their speakers are weaker.
- Start the class with Room sound check set to Advisory or Required.
- On the live class page, select Start room sound. Keep the page open. The browser keeps playing even when you switch to your slides.
- Students tap Verify room when joining. It usually takes 2-5 seconds.
Tips:
- A volume of 50-80% covers a normal classroom. For lecture halls, use the room’s PA system.
- Run Advisory for a week first, to confirm every corner of the room hears the signal.
- The check uses the phone’s microphone, so students must allow microphone access for Presence once.
How it combines with the other checks
The room sound check sits alongside, not instead of, the other layers:
- the rotating join code on the board;
- classroom and campus location checks;
- device binding;
- signed location updates throughout the class;
- face verification (optional);
- presence checks.
GPS keeps confirming throughout the class that the student has not left the building. The sound check confirms the room at join and at each presence check.
How GPS precision is handled
- Teacher capture: up to 10 readings, each weighted by its accuracy, with outliers removed. Capture stops as soon as the readings agree.
- Student phones: fixes are smoothed with a filter that weights each reading by its accuracy and ignores one-off GPS jumps, yet still notices a real walk out of the room within seconds.
- Weak signal is not “leaving”:
- If indoor accuracy drops, the student’s time keeps counting (shown as Weak GPS) for up to 5 minutes.
- A student is checked out only when they are beyond the classroom area by more than the GPS error, for about 45 seconds.
- Fake-GPS hints: identical, unrealistically precise fixes and impossible jumps are flagged to the teacher as a GPS anomaly.